A Strain Range Dependent Cyclic Plasticity Model

سال انتشار: 1395
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 339

فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد

این مقاله در بخشهای موضوعی زیر دسته بندی شده است:

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_IJE-30-2_020

تاریخ نمایه سازی: 6 شهریور 1396

چکیده مقاله:

Hysteresis loop curves are highly important for numerical simulations of materials deformation under cyclic loadings. The models mainly take account of only the tensile half of the stabilized cycle in hysteresis loop for identification of the constants which don’t vary with accumulation of plastic strain and strain range of the hysteresis loop. This approach may be quite erroneous particularly if the mean stress is not small and the effect of isotropic hardening is large. A strain dependent cyclic plasticity model which considers the variation of material constants versus strain range and accumulation of plastic strain has been proposed and experimentally investigated by the authors. In this paper it is proved that their proposed model is accurate for simulating all cycles of the hysteresis loop regardless of the strain range of the test. It is shown in this work that artificial neural network (ANN) model, if designed and trained properly, can be used for interpolating and extrapolating the experimental data. The results of this work are compared with two well-known cyclic plasticity models. The results also indicate that there is a remarkable agreement between the proposed model and ANN within and outside the strain ranges used in the experiments

نویسندگان

e Khademia

Department of Robotics, Hamedan University of Technology, Hamedan, Iran

g.h Majzoobi

Department of Mechanical Engineering, Faculty of Engineering, Bu-Ali Sina University, Hamedan, Iran

n Bonora

Department of Civil and Mechanical Engineering, University of Cassino and Southern Lazio, ۰۳۰۴۳ Cassino, Italy