Production of Single-walled and multi walled carbon nanotubes using nanoporous catalyst by CVD method

سال انتشار: 1385
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,771

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICNPGP01_053

تاریخ نمایه سازی: 16 دی 1385

چکیده مقاله:

Different types of carbon nanotubes were produced by CVD Method with catalysts contains Cobalt and molybdenum on nanoporous magnesium oxide support .The catalysts where prepared by sol-gel method. Single-walled and multi walled Carbon nanotubes grown in this catalyst using a rotary reactor and Natural gas (or methane) was used as carbon sources. TEM, SEM, XRD, TGA and Raman Spectroscopy techniques were utilized to characterize the product and the results shows that Up to 180 wt % yield of high quality, SWNTs with inner wall diameter distribution close to1.0-1.2 nm are obtained. Also in the case of multi walled carbon nanotubes the yield of product was 300% and the diameter was less than 10 nm. The result of present study shows that this is an economical method for mass production of single walled and multi walled carbon anotubes.

نویسندگان

Rashidi

Gas Division, Research institute of petroleum industry, NIOC

Akbarnejad

Catalyst and Nanostructred Materials Research Laboratory, School of Chemical Engineering, University of Tehran

Khodadadi

Carbon Research Center, Research Institute of Petroleum Industry (RIPI)

Mortazavi

Nanoelectronics center of excellence, University of Tehran