The effect of substrate's heat treatment on microstructure and mechanical properties TLP bonding X-45 and FSX-414 cobalt based superalloys

سال انتشار: 1399
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 290

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

INCWI21_012

تاریخ نمایه سازی: 19 فروردین 1400

چکیده مقاله:

In this study, a dissimilar joint of cobalt based superalloys X-45 and FSX-414 has been created under the standard heat treatment conditions with the nickel-based BNi-9interlayer with the thickness of 50μm by the transient liquid phase bonding process. Solution heat treatment (1150°C/4h) was used for bonding and the aging heat treatment(980°C/4h) for the homogenization of the bond. Optical metallography, Field Emission Scanning Electron Microscope with Energy Dispersive X-ray Spectroscopy, Differentialscanning calorimetry, micro-hardness test and shear strength test were used for the characterization of microstructural and mechanical evolution in base metals and bonds.The solution heat treatment leads to the dissolution of a part of the M23C6 and M6C carbides in the substrate of superalloys, which due to the aging heat treatment secondaryand fine carbides M23C6 precipitate in the substrate and help strengthen the superalloys. The diffusion of the boron from the molten interlayer to the base metals resulted in the complete isothermal solidification and a nickel-based single-phase solid solution has been developed. Cobalt-chromium-tungsten-molybdenum-based carboboridesprecipitation with high hardness in the vicinity of the isothermal solidification zone and in base metals results in the non-homogeneity of microhardness profile along the bonding area. Homogenization heat treatment did not have an effect on the omission of these precipitations, but by more uniform redistribution of the alloying elements strengthen solid solution that could increase shear strength from 655 to 688 MPa, which is somewhat equivalent to the shear strength of the 45-X alloy and also 93% of the shear strength of the FSX-414 alloy.

نویسندگان

Mojtaba Naalchian

Advanced Materials Research Center, Department of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran

Masoud Kasiri-Asgarani

Advanced Materials Research Center, Department of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran

Morteza Shamanian

Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran

Reza Bakhtiari

Department of Materials Engineering, Faculty of Engineering, Razi University, Kermanshah, Iran.

Hamid Reza Bakhsheshi- Rad

Advanced Materials Research Center, Department of Materials Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran