Three-Dimensional Finite Element and Experimental Simulation of magnetic flux leakage-type NDT for Detection of Pitting Corrosions

سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 478

فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICTINDT04_068

تاریخ نمایه سازی: 18 مرداد 1398

چکیده مقاله:

Magnetic flux leakage (MFL) testing is the most commonly used and cost effective method of estimating the extent of damage caused by corrosion in gas and oil transmission pipelines. In this paper, based on the Maxwell Equations, three-dimensional simulation on pitting corrosion inspection in 10 mm thick carbon steel plate using MFL has been carried out. A FEM-based COMSOL software in magnetostatic mode has been used for three-dimensional simulation. The MFL signals of defects, which have the same length, same width, and different depths, have been studied. The MFL signals have also been obtained experimentally using an experimental set-up at the laboratory facilities on a 10 mm thick carbon steel plate containing pitting corrosions. Good agreements between FEM simulation and experimental results confirms the potential of the three-dimensional simulation for MFL inspection.

نویسندگان

Turaj azizzadeh

PhD student, Iran university of science and technology;

Mir saeed safizadeh

Associate professor, Iran university of science and technology;