WELDING of Cr-Mo STEELS for ENERGETIC INDUSTRY
سال انتشار: 1396
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 421
فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
INCWI18_063
تاریخ نمایه سازی: 21 اردیبهشت 1397
چکیده مقاله:
Paper gives an overview and main characteristics of low alloyed steels based on chromium and molybdenum as the main alloying elements. Chrome-moly steels are intended for high temperature applications especially for the need of energetic industry. Welding issues of these steels is presented and general recommendations for welding of CrMo steels are presented. In experimental part of this paper GTA welding of 10 CrMo 9 10 tubes in 5G position were performed in such a ways that approved welding procedure specification (WPS) was, regarding thermal conditions and prerequisites disobeyed, (no preheating and no control of interpass temperatures) without and with tubes restrain and with complete obeying of WPS using restrain. Disobeying adequate welding procedures can result in detrimental quality loss by welding of 10 CrMo 9 10 tubes.
کلیدواژه ها:
نویسندگان
Nikša KRNIĆ
UNIVERSITY OF SPLIT, FACULTY OF ELECTRICAL ENGINEERING, MECHANICAL ENGINEERING AND NAVAL ARCHITECTURE (FESB), Department of Production Engineering, Welding Laboratory,
Goran GAŠPAR
INDUSTRIUS Ltd., Bajagić ۱۱, ۲۱۲۴۱ Obrovac Sinjski and Dolačka ۷۴, ۲۲۰۰۰ Šibenik, CROATIA,www.industrius.eu, M. Mech. Eng., International/European Welding Engineer (IWE/EWE)
Mohammad AZIZMORADI
MACHINE SAZI ARAK Co., ۴th km of Teheran Road, Arak, IRAN, M. S. Mech. Eng