Preparation and characterization of Al- 4.5 Mg alloy by mechanical alloying

سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 337

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

IIAC04_022

تاریخ نمایه سازی: 22 دی 1396

چکیده مقاله:

An aluminium alloy composition corresponding to Al-4.5Mg-0.5Mn was prepared by powder metallurgy route and mechanical alloying. The powder mixture was subjected to high energy ball milling at constant milling speed and constant ball to powder ratio of 20:1, but varying milling time for 5-20 hours. Effect of milling time on particle size, morphology, lattice parameter, and crystallite size and lattice strain were studied by using scanning electron microscope and X-Ray diffraction patterns. It was found that magnesium completely dissolved in aluminium matrix after 20 hour milling and the crystallite size reduced to 16.8 nm.

نویسندگان

S Rastgarnia

Materials Science and Engineering Department, Shahid Chamran University, Ahvaz, Iran

Khalil Ranjbar

Materials Science and Engineering Department, Shahid Chamran University, Ahvaz, Iran

Kh Gheisary

Materials Science and Engineering Department, Shahid Chamran University, Ahvaz, Iran