Experimental Investigation of Determining Optimum Pressure for Separation of Wellhead Fluids
محل انتشار: دومین کنگره مهندسی نفت ایران
سال انتشار: 1386
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,063
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
IPEC02_102
تاریخ نمایه سازی: 22 خرداد 1391
چکیده مقاله:
The oil industry deals with wellhead fluids which are a mixture of hydrocarbon compounds, water and impurities. In two-phase separator design, the gas and liquid phases of a fluid stream are mechanically separated at a specific temperature and pressure. Proper separator design is important, because a separation vessel is normally the initial processing vessel in facility. Improper design can bottleneck and reduce the capacity of the entire facilities. The optimum pressure is defined as that pressure at which the maximum liquid volume is accumulated in the stock tank per volume of reservoir fluid produced.In this paper, by using the Flash Equilibrium Separator,gasometer and densimeter apparatuses, the optimum pressure for an Iranian oil sample was obtained and also gas-oil ratio, oil formation volume factor and residual oil gravity were indicated all as a function of separator pressure at the desired temperature
کلیدواژه ها:
نویسندگان
Seyed Ahmad Mirhaj
Petroleum University of Technology, Exploration Directorate Co., Petroleum University of Technology
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :