Formation Methods and Properties of Gaseous Hydrates

< p>Underground gas reserves in the form of hydrates are a huge source of energy that researchers are looking for ways to extract. The amount of hydrate gas reserves is estimated at more than 1016 cubic meters, which is more than the discovered sources of other fossil fuels, if only 15% of this gas is extracted. But due to problems such as the slow rate of hydrate formation and the high pressure of its formation, his idea remained in the laboratory. After the discovery of hydrate self-preservation, this idea was raised more seriously and a lot of research was done on the use of hydrate for gas storage and transmission. High gas pressure is the most important negative factor in mass production of hydrates for gas storage and transport. The results showed that using these materials, methane hydrate is formed in much more suitable conditions than temperature and pressure. While the equilibrium pressure of methane hydrate formation at 293 ° K is about 34 MPa, with the addition of tetra-hydro-furan at a concentration of 2.5 mol%, this pressure is reduced to about 2.49 MPa, which shows a decrease of 92.6%. Also, at a pressure of 5 MPa, the equilibrium temperature of methane hydrate is about 278 degrees Kelvin, while at the same pressure, the fuzzy equilibrium temperature of a 6 mol solution of tetra-hydro-furan was about 306 degrees Kelvin.

کلیدواژه ها:

hydrate ، Gas ، Methane ، Tetra-hydro-furan ، Equilibrium Pressure