A Finite Element Simulation during Selective Laser Melting; Effect of Processing Parameters

سال انتشار: 1399
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 504

فایل این مقاله در 15 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

IMES14_254

تاریخ نمایه سازی: 1 دی 1399

چکیده مقاله:

Selective laser melting is a novel manufacturing process, in which a very high temperature gradient is occurred. Therefore, thermal simulations are necessary to predict the maximum temperature, thermal history, and melt pool dimensions. In this research, a 3D non-linear transient finite element model was developed to investigate the effect of processing parameters such as laser scan speed and laser power on maximum temperature and melt pool dimensions. The finite element model was adaptively remeshed at every increment and consequently, the computational time was increasingly reduced. Using the results of the finite element analysis, the maximum temperature and melt pool dimensions for different laser scan speed and laser power for Ti-6Al-4V were calculated. According to the results, the laser power effect on maximum temperature is more than that of laser scan speed. In addition, after a certain amount of increasing the volume energy density, the maximum temperature and melt pool dimensions will be less affected by further increasing the amount of volume energy density. Finally, the effect of processing parameters on depth of penetration was investigated and the optimum parameters for melting the total powder layer was reported.

نویسندگان

S.R Eatezadi

Master Student, Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran

A Kermanpur

Professor, Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran

E Foroozmehr

Associate Professor, Mechanical Engineering Department, Isfahan University of Technology, Isfahan, Iran

M Javanbakht

Associate Professor, Mechanical Engineering Department, Isfahan University of Technology, Isfahan, Iran