The New Generation Of Drilling Cost Optimization By Simulation
محل انتشار: چهاردهمین همایش بین المللی نفت، گاز و پتروشیمی
سال انتشار: 1389
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,120
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
IOGPC17_106
تاریخ نمایه سازی: 3 آبان 1389
چکیده مقاله:
weight on bit , rotary speed , bit hydraulics and more importantly bit types , are the most important parameters affecting rate of penetration and consequently the economics of drilling . Pulling a worn bit is necessary to make the drilling operations more efficient . cost per foot calculation is a popular criterion used to predict when to pull a bit.in this paper , some first 3 thousands feet of a reservoir lithology including four bit runs are analyzed so that factors affecting penetration rate are optimized and the lowest possible well cost is achieved. the effects of using other bit types, weight on bit rotary speed and bit hydraulics are simulated in an attempt to determine the optimized parameters which result in the lowest drilling cost overall, it was found that in bit runs 2,3 and 4 some lower cost per foot can be achieved using milled tooth bits instead of tungsten carbide types. furthermore it can be concluded that by increasing weight on bit and reducing rotary speed in harder rocks more favorable results are obtained while in softer rocks it is vice versa.
کلیدواژه ها:
نویسندگان
EISA NOVIERI
M.Sc in petroleum engineering
saeid m
M.Sc in software engineering