Numerical approach to select central frequency of ultrasonic probe in thickness measurement of pipe

سال انتشار: 1398
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 462

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ISME27_693

تاریخ نمایه سازی: 8 مرداد 1398

چکیده مقاله:

Ultrasonic thickness gauges are often used when the inspector accesses only one part of various products whose thickness needs to be determined such as pipe or tube, or where simple mechanical measurements are impossible or impractical due to section size or accessrestriction or something like this. Considering this application, specifying test equipment parameters like probe diameter, frequency, piezoelectric material, excitation voltage and so on would help the convenience of measuring the thickness. Since thickness is concernedhere, central frequency of ultrasonic transducer has crucial effect on measurement. In this article, 2-D solid mechanic simulation was carried out by FEM to investigate acceptable central frequency of ultrasonic transducer to measure thickness of circular sections. Theresults demonstrate that frequency increase cause to increase near filed area which is not sufficient for thickness measurement. Both near field and wave divergence angle should be at suitable value to have uniform echo pulse and determine thickness

نویسندگان

Vajihehsadat Sajadi

Msc. Student of Mechanical Engineering, Tafresh University

Mohammad Reza Sheykholeslami

Assistance Professor, Arak University

Siamak Mazdak

Assistance Professor, Tafresh University