Experimental Study and Simulation of Effects of Entrance Angle and Bearing Length on Force and Dimensional Accuracy in Extrusion Process
سال انتشار: 1397
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 378
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME15_004
تاریخ نمایه سازی: 3 اردیبهشت 1398
چکیده مقاله:
The extrusion process is one of the metal forming methods used to reduce the thickness or cross-section of the material. In current research, a lead rod with circular cross-section is converted to a square shape by passing through an extrusion die. Various parameters affect the extrusion process, including the bearing length, die entrance angle, press velocity, and lubricant type. In this paper, the effects of the entrance angle and the length of the deformation zone (bearing length) are studied experimentally and numerically on the dimensional accuracy of the deformed specimens and the forming force. For this purpose, four dies with bearing lengths of 2 and 5 mm, and an entrance angles of 30 and 45degrees are used. Based on the results, it can be concluded that by decreasing the entrance angle and increasing the bearing length, the dimensional accuracy of the product will be increased and the highest force will be required during the forming process
کلیدواژه ها:
Direct extrusion- Dimensional accuracy- Bearing length- Entrance angle.
نویسندگان
Mirshaban Jafari
PhD student, Mechanical Engineering Dept., University of Birjand, Birjand, Iran
S. M.Hossein Seyedkashi
Associate Prof., Mechanical Engineering Dept., University of Birjand, Birjand, Iran