Effect of Ultrasonic Vibration of Tool on Electrical Discharge Machining of Tungsten Carbide (WC-Co)
سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,473
فایل این مقاله در 16 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME07_030
تاریخ نمایه سازی: 6 آذر 1388
چکیده مقاله:
This paper deals with the effect of copper tool vibration with ultrasonic (US) frequency on the electrical discharge machining (EDM) characteristics of tungsten carbide (WC-Co). It is found that ultrasonic vibration of the tool (USVT) is more effective in attaining a high material removal rate (MRR) in low current and low pulse time (finishing regimes), and in general the surface roughness and tool wear ratio (TWR) increase. It is observed that ultrasonic vibration of the tool significantly reduces arcing and open circuit pulses, and the stability of the process is increased. This study shows that, there are optimum conditions for ultrasonic assisted machining of tungsten carbide,although the conditions may vary by giving other input parameters for those which have been set constant in the present work.
کلیدواژه ها:
Electrical Discharge Machining ، Ultrasonic assisted EDM ، Ultrasonic Vibration of the Tool ، Tungsten Carbide (WC-Co) ، Material Removal Rate ، Surface Roughness ، Tool Wear Ratio
نویسندگان
Amir Abdullah
No ۴۲۴, Hafez Ave., Department of MechanicalEngineering, Amirkabir University of Technology,Tehran, Iran
Mohammad R. Shabgard
Department of Mechanical Engineering, University ofTabriz, Tabriz, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :