Investigation of powder densification in floating and single action dies to produce dense compacts with high aspect ratio

سال انتشار: 1397
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 724

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

PMAUTO06_095

تاریخ نمایه سازی: 23 آذر 1397

چکیده مقاله:

In this study the commercially pure Aluminum powders were compacted by single action and floating dies at room temperature. The effect of compaction method on densification was studied using density distribution, micro-hardness measurements and scanning electron microscope (SEM) along compaction axis of processed samples. The density measurements of compacted samples through floating die process show the uniform density distribution in comparison to single action process which are in good agreement with micro-hardness and SEM results. Results also show that the densification requires lower compaction load in floating die process than it in single action compaction process which is due to improvement of frictional condition by change in relative movement in the frictional surfaces of floating die process. Therefore it makes floating die more beneficial in producing dense compacts with high aspect ratio (ratio of height to diameter) which is not possible in single action die compaction process.

نویسندگان

h Homayoun

Department of Materials Science and Engineering, School of Engineering, Shiraz University, Shiraz, Iran

m Shahbaz

Department of Materials Science and Engineering, School of Engineering, Urmia University, Urmia, Iran

r Ebrahimi

Department of Materials Science and Engineering, School of Engineering, Shiraz University, Shiraz, Iran