Investigation titanium-Graphene nanocomposite fabrication by powder metallurgy

سال انتشار: 1397
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 336

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

PMAUTO06_024

تاریخ نمایه سازی: 23 آذر 1397

چکیده مقاله:

With the Increasing in use of titanium and its alloys in the aerospace, marine, oil and gas industries, implants and etc ; different engineers have been forced to improve the various properties of titanium. Graphene is a great way to improve its performance. Therefore, in this research, the fabrication of titanium-graphene composite by powder metallurgy method has been investigated. But most important challenge in the use of graphene is uniform distribution, maintaining structural powder and Transition of proper stress in the titanium graphene interface. Here, we are trying to overcome these challenges with three techniques press, SPS, and hot rolling Which ultimately leads to an increase in mechanical properties. After the fabrication of graphene-titanium composite, the mechanical properties of the composite were investigated by analyzes XRD, SEM, TEM and it was observed significantly increased in mechanical properties

نویسندگان

Seyed Mohammad Musavi Nezhad

MSc, Faculty of Material Engineering, Semnan University,Semnan,iran

Esmaile Emadodin

associate professor, Faculty of Material Engineering, Semnan University,Semnan.iran

Reza Askarnia

MSc, Faculty of Material Engineering, Semnan University,Semnan,iran