Comparison of Wear Behavior of Combustion Synthesized TiB/Ti and Sintered SiC in Wear Test

سال انتشار: 1387
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,660

فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICME09_046

تاریخ نمایه سازی: 5 آبان 1388

چکیده مقاله:

Due to low cost and simplicity of combustion synthesis, in this research, the combustion synthesized TiB/Ti was evaluated in comparison sintered SiC specimens for use as seal ring in pump. Therefore wear behavior of TiB-24%wt. Ti samples was determined by pin on disk test against an AISI 52100 steel pin under dry condition. Microstructure observation with SEM and constituted phases were recognized with X ray diffraction analysis. In wear test, experimental results showed that TiB-Ti has friction coefficient lower than SiC in loads lower than 240 N similar working conditions. Also shows weight loss close to SiC in wear test. The density of the synthesized bulk samples was measured by using water, according Archimedes test method and both samples show low density. Also macro hardness results showed that TiB/Ti has hardness as high as SiC that is suitable for use in pumps. Therefore result showed that TiB/Ti has acceptable primary condition for evaluation in pump as mechanical seal rings.

کلیدواژه ها:

Combustion Synthesized TiB-Ti Composite ، Sintering SiC ، Mechanical Seal Rings ، Wear Test

نویسندگان

M.B Rahaei

Ph.D. Student of Materials Science, Materials & Energy Research Center

A Shafyei

Assistant Professor of Materials Science, Isfahan University of Technology

M Kholghy

M.Sc. of Materials Science, Isfahan University of Technology

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • D. Richerson: Modern Ceramic Engineering: Properties, Processing, and Use in ...
  • Iranian Conference on Man ufacturing Engineering (ICME2009) March 3-5, 2009, ...
  • L. Harmon "Silicon carbide Bushings Help Seal Less Pump Prevent ...
  • G.C. Smith, D. Park, K.J. Titchener, R.E. Davies and R.H. ...
  • O.C. Zienkiewicz and J.Z. Zhu "A Simple Error Estimator and ...
  • R. Wasche and D. Klaffke "In Situ Formation of Tribologically ...
  • R. Wasche, D. Klaffke and T Troczynski "Tribological Performance of ...
  • V. Ocel k, D. Matthews and J.Th.M. De Hosson "Sliding ...
  • Zhang Xinghong, Xu Qiang, Han Jiecai and V.L. Kvanin "Self ...
  • M.J. Neale and M.G. Gee "Guide to Wear Problems and ...
  • M. Cirakoglu, S. Bhaduri and S.B. Bhaduri "Combustion Synthesis Processing ...
  • T. Yamamoto, A. Otsuki, K. Ishihara and P.H. Shingu "Synthesis ...
  • R.L Fusaro "Preventing Space Craft Failures Due to Tribological Problems". ...
  • نمایش کامل مراجع