Comparison of mixing characteristic of bubble column and airlift reactors using tracer injection technique
محل انتشار: ششمین کنگره بین المللی مهندسی شیمی
سال انتشار: 1388
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,861
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICHEC06_024
تاریخ نمایه سازی: 1 مهر 1388
چکیده مقاله:
The liquid mixing time in a bubble column reactor and in an internal loop airlift reactor were investigated. The total volume and diameter of two reactors as well as the type of gas sparger were the same. The riser to downcomer cross sectional area ratio (Ar/Ad) was 0.64 in the airlift reactor. The tracer injection method and impulse response was used to find the mixing time. The experimental results showed that the lower values of mixing time were related to internal loop airlift reactor compared to the bubble column reactor at the identical gas flow rate. The mixing time decreases with increasing the superficial gas velocity, with a power correlation. The exponent values were determined -0.86 for bubble column reactor and -0.48 for airlift reactor. The dimensionless mixing time depends only on the reactor geometry. Its dependence to the superficial gas velocity was negligible. Using airlift reactor instead of bubble column reactor shows that mixing time reduced about 50% at low gas flow rates.
کلیدواژه ها:
نویسندگان
J Behin
Department of Chemical Engineering, Faculty of Engineering, Razi University, Kermanshah, Iran
M Zeyghami
Department of Chemical Engineering, Faculty of Engineering, Razi University, Kermanshah, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :