Spring back Reduction In Sheet Metal Bending Of A Z-Shape Process
سال انتشار: 1394
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 535
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
DSCONF01_039
تاریخ نمایه سازی: 30 بهمن 1394
چکیده مقاله:
In this paper, a die shape optimization method for reduction of spring back defect due to elastic recovery behaviour in Sheet metal bending process is presented by using the reduced basis technique coupled by finite element and design of experiments methods. The primary objective of the proposed method is to reduce the enormous number of design variables required to define the initial die angle. The reduced basis technique is a weighted combination of several basis angles. The aim of the method is to find the best combination using the weights for each angle as the design variables. A multi-level design process is developed to find suitable basis angle at each level that can be used in the reduced basis technique. Each level is treated as a separated optimization problem until the required objective is achieved. The experimental design of Taguchi method is used to build the approximation model and to perform optimization. This method is demonstrated on the die angle optimization of Sheet metal bending of a Z-shape.
کلیدواژه ها:
نویسندگان
Seyed Sajjad Kiani
MSc Student, Department of Mechanical Engineering, Faculty of Engineering, Arak University Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :