The effect of dielectric types on the machining Characters in EDM process
محل انتشار: کنفرانس بین المللی علوم و مهندسی
سال انتشار: 1394
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 557
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICESCON01_0532
تاریخ نمایه سازی: 25 بهمن 1394
چکیده مقاله:
This paper studies, the effect of Dielectric type (kerosene oil and De-ionized Water) on the output parameters (material removal rate, tool wear ratio, surface roughness) in electrical discharge machining (EDM) of -TiAl intermetallic compounds. The results showed that increasing pulse current and pulse on time in both of dielectric fluids has upward trend on material removal rate and with using kerosene dielectric the material removal rate is always higher and tool wear ratio is lower than the one with de-ionized water. Also Surface roughness of machined parts in kerosene at low pulse current is less than the machined ones in de-ionized water.
کلیدواژه ها:
نویسندگان
Mohammad Reza Shabgard
Department of Mechanical Engineering, University of Tabriz ,Tabriz, Iran
Hadi Eivazi Bagheri
Young Researchers and Elite Club, Tabriz Branch, Islamic Azad University, Tabriz, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :