Simulation of hypersonic flow inside a typical wind tunnel along with the model inside the test section

سال انتشار: 1394
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 458

فایل این مقاله در 15 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICESCON01_0517

تاریخ نمایه سازی: 25 بهمن 1394

چکیده مقاله:

In this paper, the transient simulation of hypersonic flow is performed inside a typical blowdown-indraft wind tunnel along, with the standard model inside the test section. This study aims to investigate the sample hypersonic wind tunnel start procedure as well as its transient flow physics and aerodynamics. Due to lack ofpossibility of accurate comparison between the experimental and numerical results in transient condition, the selected turbulence models are investigated first and the SST/k-ω model is chosen for the numerical solution among them. After that, the steady flow solution is performed for the HB2 standard model and the acquiredresults are compared with the experimental ones. After turbulence model validation, specifying the assumptions,and studying the grid in steady flow, the transient flow is numerically simulated across the entire wind tunnel domain including the nozzle, the test section and the diffuser. The acquired results from the transient numerical solution show that a shock wave is formed after the nozzle throat and it moves toward downstream of the tunnel internal flow. The results of the performed analyzes present the required time intervals for the tunnel start, shockwave motion as well as its passage over the model, and finally, development of the steady state flow across theentire tunnel both, quantitatively and qualitatively. This study facilitates reaching improved understanding and correct perception of the aerodynamic procedure of the tunnel start and possible obstacles along the way of extracting design conditions and applications of hypersonic wind tunnels. Both, steady and transient numerical solutions are performed using finite volume method and the flow is assumed to be axisymmetric

نویسندگان

Mohammad-Reza Heidari

Associate Professor of Department of Aerospace Engineering, Islamic Azad University,Parand Tehran, IRAN P.O.B 6673637673

Seyed Mohammad-Hosein Mousavi-Sajad

Aerospace graduate student of Islamic Azad University

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • _ _ _ _ Boundary Layer over Straight and [6] ...
  • Deem, R.E., Jn(3373). Pressure and heat-transfer distribution tests on a ...
  • _ _ _ _ _ model HB3 ...
  • Juliano, T.J et al. (2139), "Quiet Tunnel Measuremens of HIFiRE-9 ...
  • Mittal, S. and Yadav, S. (21 13), "Computation of Flows ...
  • M ohammadifard F., et al , .(2136) "Investigation of Flow ...
  • Spalart, P. R. and Allmaras, S. R., (3332) _ One-Equation ...
  • نمایش کامل مراجع