Effect of milling time and microwave sintering on the microstructure and micro-hardness of nano-structured Cordierite
سال انتشار: 1393
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 485
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICNN05_611
تاریخ نمایه سازی: 30 آبان 1394
چکیده مقاله:
The purpose of this research is to investigate the sintering of cordierite (34.86 wt% Al2O3, 51.36 wt% SiO2and 13.78 wt% MgO) nano-grains synthesized by mechanical activation route. Samples were prepared by the high-energyball milling of the starting powders followed by conventional and microwave sintering at 1390°C. SEM observationsillustrated the equiaxed nano-grains of cordierite with an average grain size of 30 nm for samples sintered in microwave.With the increase of milling time, samples sintered at 1390°C in microwave furnace obtained lower porosity, higherdensity and microhardness than those sintered at the same temperature in conventional furnace. Sample milled for 30 hand sintered in microwave furnace at 1390°C obtained the maximum microhardness of 1089±5 kg/mm2.
کلیدواژه ها:
نویسندگان
Marzieh Kiani
Materials & energy Research Centre, Alborz, Iran
Touradj Ebadzadeh
Materials & energy Research Centre, Alborz, Iran