Effect of process parameters on roundness of flow formed tubes, a Taguchi approach

Flow forming is an advanced, chip-less and costeffective metal forming process to produce precise, seamless, axi-symmetric tubular products. This studywas carried out to analyze the effect of process parameters on roundness of flow formed parts. The experiments were carried out using a commercial purecopper UNS C11000 tubular pre-form. Thickness reduction ratio, Feed rate and Angular speed of mandrel were considered as variables. A set of rollerand mandrel was designed and manufactured to convert an NC lathe to a single roller flow forming machine. This present investigation uses Taguchimethod, which is a powerful design of experiments tool. This method provides a simple, efficient and systematic approach to determine optimal formingparameters. An L9 orthogonal array of Taguchi method was applied to carry out the design of experiments. ACMM machine was used to measure the roundness error of parts. The analysis of result was performed based on average of results and analysis of variance.Through ANOVA analysis it was revealed that the feed rate is the most significant variable that affects the roundness followed by thickness reduction ratio. Theminimum roundness error of 9 μm was obtained when variable parameters were adjusted at optimum values. Comparison of optimum value of roundness error andoverall average of roundness error showed a significant improvement in roundness.

کلیدواژه ها:

Taguchi method ، Flow forming ، Roundness ، ANOVA