Using Taguchi Method to Optimize Recovery of Bismuth by Electrolysis
محل انتشار: مجله شیمی فیزیکی و الکتروشیمی، دوره: 3، شماره: 1
سال انتشار: 1394
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 83
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JPEM-3-1_007
تاریخ نمایه سازی: 24 بهمن 1402
چکیده مقاله:
This paper presents a methodology, based on the taguchi parameter design approach, for the optimization of process parameters for bismuth recovery from aqueous solutions. The process parameters considered are [Bi۳+], [NaCl], temperature, and cathodic current density. In addition, cell voltage and current efficiency as two responses have been considered. An orthogonal array L۹, the signal-to-noise (S/N) ratio, and the analysis of variance were used to analyze the effect of selected process parameters and their levels. From a metallurgical point of view, the separation and recovery of bismuth from a bismuth glance concentrate through leaching, purification and electrowining of chloride solutions were carried out. The optimum conditions for the selected parameter values were found as [Bi۳+] (۷۵ g/L), [NaCl] (۲۵ g/L), temperature (۶۵°C) and current density (۱۰۰ A/m۲). Finally, a mathematical model has been proposed and the results of a confirmatory run are reported to verify the results, which indicate that this methodology is more efficient in optimizing the process parameters.
کلیدواژه ها:
This paper presents a methodology ، based on the taguchi parameter design approach ، for the optimization of process parameters for bismuth recovery from aqueous solutions. The process parameters considered are [Bi۳+] ، [NaCl] ، temperature ، and cathodic current density. In addition ، cell voltage and current efficiency as two responses have been considered. An orthogonal array L۹ ، the signal-to-noise (S/N) ratio ، and the analysis of variance were used to analyze the effect of selected process parameters and their levels. From a metallurgical point of view ، the separation and recovery of bismuth from a bismuth glance concentrate through leaching ، purification and electrowining of chloride solutions were carried out. The optimum conditions for the selected parameter values were found as [Bi۳+] (۷۵ g/L) ، [NaCl] (۲۵ g/L) ، temperature (۶۵°C) and current density (۱۰۰ A/m۲). Finally ، a mathematical model has been proposed and the results of a confirmatory run are reported to verify the results ، which indicate that this methodology is more efficient in optimizing the process parameters
نویسندگان
Rasoul Khayyam Nekouei
School of Metallurgy and Materials Engineering, College of Engineering, University of Tehran, Tehran, Iran
Amir Peyman Soleymani
Department of Materials Engineering , Isfahan University of Technology, Isfahan, Iran
Saeed Akhavan
Department of Materials Engineering , Isfahan University of Technology, Isfahan, Iran
Ali Ashrafi NasrAbadi
Department of Materials Science Engineering, Sharif University of Technology, Tehran Iran
Alireza Aghababaei Samani
Department of Materials Engineering , Isfahan University of Technology, Isfahan, Iran