CORRECTION OF FLUX ERROR IN LOW SPEED RANGE OF DTC DRIVES OF INDUCTION MACHINES

سال انتشار: 1401
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 221

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_EECS-2-2_004

تاریخ نمایه سازی: 13 شهریور 1402

چکیده مقاله:

The conventional direct torque control (DTC) method suffers a flux drop at low speeds, which is due to the long selection of zero (neutral) voltage vectors in these speed areas. Past studies with the continuous switch of direct and reverse active vectors to achieve proper flux adjustment, this procedure causes high and consecutive overshoots in the hysteresis band that causes a sharp increase in the switching frequency and increase in the torque and current ripple, which means decrease in the drive efficiency. In this article, a modified method for setting the standard DTC current is introduced, which can be achieved by controlling only one band (low or high band) at low speeds. The introduced method by reducing the selection of zero voltage vectors and at the same time minimizing the number of reverse voltage vectors prevents the loss of flux in low speed areas. In addition, it is effective in reducing torque ripple and current in low speed mode and a significant reduction in switching frequency will also be achieved. The effectiveness of the proposed method in the simulation which is done in MATLAB software will be proved.

نویسندگان

Mohsen Dashtbani

Hakim Sabzevari University

Majid Hasanzadeh

Hakim Sabzevari University

Reza Roshanfekr

Hakim Sabzevari University, Computer and electrical department

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Marulasiddappa HB, Pushparajesh V. Review on different control techniques for ...
  • Faizal A, Miefthawati NP, Kurniawan R, Marzuki CC. Direct Torque ...
  • Maghfiroh H, Iftadi I, Sujono A. Speed Control of Induction ...
  • Dianguo Xu, Bo Wang, G. Zhang, G. Wang, Young Yu. ...
  • Kohlrusz G, Fodor D. Comparison of Scalar and Vector Control ...
  • Tekam MS, Sharma DAK. Comparative Study of Field Oriented Control ...
  • J. N. Nash, "Direct torque control, induction motor vector control ...
  • D. Mohan, X. Zhang and G. H. B. Foo, "Three-Level ...
  • Savarapu S, Qutubuddin M, Narri Y. Modified Brain Emotional Controller-Based ...
  • Yang Y, Wang Q, Shang J. Five-Level Hysteresis DTC of ...
  • Loncarski J, Monopoli VG, Leuzzi R, Cupertino F. Operation analysis ...
  • I. M. Alsofyani, N. R. N. Idris, and Y. A. ...
  • نمایش کامل مراجع