Evaluation of the effect of the variables of the friction stir welding of۱۰۵۰ Al and copper on the properties of the joint

سال انتشار: 1401
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 297

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

INCWI23_101

تاریخ نمایه سازی: 16 اسفند 1401

چکیده مقاله:

In this research, friction stir welding of aluminum ۱۰۵۰ to copper with variable speedwas investigated. For friction stir welding, rotational speeds of ۹۰۰ and ۱۲۰۰ rpm andtravers speeds of ۳۶, ۶۳ and ۱۲۵ mm/min were used. In order to check the phases andmicrostructure, scanning electron microscope analysis, X-ray spectrometry and hardnesstesting were used. The disturbance zone included Al۲Cu۳, Al۴Cu۹, AlCu۴, Al۲Cu andAlCu phases. The results showed that the formation of intermetallic phases and severeplastic deformation in the welding area caused an increase in hardness. The highest valueofhardness in the stirred area was ۹۷.۸ Vickers and at a rotation speed of۹۰۰ rpm and anadvance speed of۳۶ mm/min.

نویسندگان

M Ahmadi

Department of Mechanical Engineering, Kermanshah Branch, Islamic Azad University, Kermanshah

H. Reza Ahmadi

Assistant Professor of Materials Engineering, Saveh Branch, Islamic Azad University, Saveh

M.R Khanzadeh

Associate Professor, Technical and Engineering Faculty, Mobarakeh Branch, Islamic Azad University,Mobarakeh, Isfahan

H Bakhtiari

PhD students, Materials and Energy Research Center, Ceramics Research Institute, Karaj