Investigation of the effect of hatch space parameter on mechanical properties of titanium alloy produced by SLM additive manufacturing method by DIC technique
سال انتشار: 1400
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 151
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
INCWI22_071
تاریخ نمایه سازی: 16 فروردین 1401
چکیده مقاله:
Due to the increasing development of additive manufacturing (AM) in manufacturing and production, especially in sensitive and advanced industries, such as aerospace, military and automotive industries and the numerous uses of this technique for the production of titanium parts, this study tries to The results of changes in one of the most effective factors in the production process on the mechanical properties of titanium alloy coupon (Ti-Al۶-۴V) to be presented by the digital image correlation technique. Due to the wide application of SLM technique in production methods of additive manufacturing of steel structures, changing the effective production parameter of the effect of laser beam overlap on mechanical properties, including; The final yield strength, the percentage of elongation of the produced parts and the effect of laser energy density on the changes in mechanical properties have been investigated. The technique used toextract the mechanical properties is also digital image correlation (DIC) of optical and non-contact methods in part surface inspection. Due to the fact that the overlap distance indicates the penetration of two laser beams along the part, its non-penetration causes undiluted powder remaining in the fabrication process and its excessive penetration also causes gas cavities and thus porosity in the part. Becomes final. Therefore, for optimal product production, there is an optimal value for the parameter.
کلیدواژه ها:
نویسندگان
Morteza Zarnegar
Master Student, Mechanical School of Tehran University
Mohammadreza Farahani
Phd, Mechanical School of Tehran University
Yaser Vahidshad
Phd, Space Transportation Research Institute, Iranian Space Research Center
Mohammadjavad Pakravan
Phd Student, Mechanical School of Tehran University