Heat Transfer in the Impinging Synthetic Jet Cooling: Frequency and Jet-to-Surface Effects
محل انتشار: دهمین همایش انجمن هوافضای ایران
سال انتشار: 1389
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,362
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
AEROSPACE10_108
تاریخ نمایه سازی: 2 اسفند 1390
چکیده مقاله:
The synthetic jet is a jet with zero net mass flux usually produced by oscillating a diaphragm placed on a cavity. The cooling performance of the impingement synthetic jet is investigated numerically in a scaled up model that enables high resolution thermal and flow measurements. The test setup comprises of two circular parallel plates where one plate contains an integrated jet actuator and the opposite plate includes a constant heat flux of 18 W. Effects of jet formation frequency at the orifice outlet and jet-to-surface distances (H/d) at constant Reynolds number are investigated. The cavity and diaphragm are omitted and a harmonic time-dependent velocity profile is assumed at the orifice outlet. Also, the 2vf− turbulence model is applied as a suitable model for problems with stagnation points. Solution of the governing equations under the assumptions of incompressible, axisymmetric and temperaturedependent properties is carried out. The PISO algorithm is employed for the coupling of continuity and momentum equations. Results show that the Nusselt number increases as jet to surface distance raises. However, this increase does not continue for all the quantities. Also, for small distances between the synthetic jet and the heated surface, the high formation frequency synthetic jet removes heat better than the low frequency jet, whereas the low frequency jet is more effective at larger distances.
کلیدواژه ها:
Synthetic jet-Impinging jet- Unsteady heat transfer-Jet cooling-Turbulence modeling
نویسندگان
Farzad Bazdidi-Tehrani
Corresponding Author, Associate Professor, Heat Transfer Research Laboratory, Department of Mechanical Engineering, Iran University of Science and Technology, Tehran
Akbar Eghbali
M.Sc. Student
Mahdi Karami
Ph.D. Candidate
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :