Effect of Twist Extrusion Process on the Mechanical Properties and Microstructure Evolution of ۷۰-۳۰ Brass Alloy
محل انتشار: فصلنامه مواد پیشرفته و فرآوری، دوره: 6، شماره: 4
سال انتشار: 1397
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 188
فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JMATPR-6-4_004
تاریخ نمایه سازی: 7 مهر 1400
چکیده مقاله:
In this study, cartridge brass alloy was severely deformed by twist extrusion (TE) technique and its mechanical properties, before and after TE, was investigated using a die with the twist line slope of β = ۳۰°. It was revealed that large strains imposed on the material by this advanced method of severe plastic deformation (SPD) led to a nano-scale ultrafine microstructure and to an enhancement of the mechanical properties. It was revealed that the more TE passes a finer grain sized microstructure obtained. Also, by increasing the number of TE passes, the yield strength and ultimate tensile strength increased. Microhardness test results show that the hardness increases from ۵۵ (initial sample) to ۱۱۰ HV and ۱۴۰ HV in the center and lateral edges of the sample pass #۱ TE, respectively. After six passes of twist extrusion, the microhardness of the center and lateral edges of the sample reaches ۱۶۰ HV.
کلیدواژه ها:
نویسندگان
Sara Hosseini Faregh
Department of Materials Science and Engineering, Faculty of Engineering, Semnan University, Semnan, Iran
Amir Hasani
Department of Materials science and Engineering, Faculty of Engineering, Semnan University, Semnan, Iran
Majid Naseri
Department of Materials Science and Engineering, Faculty of Engineering, Shahid Chamran University of Ahvaz, Ahvaz, Iran