Study of Mechanical Properties of ۷۰۷۵ Aluminum Alloy Due to Particle Size Reduction due to Constrained Groove Pressing CGP Process
سال انتشار: 1400
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 276
فایل این مقاله در 14 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_MPMPJ-10-1_001
تاریخ نمایه سازی: 8 تیر 1400
چکیده مقاله:
Today, one of the new approaches of researchers to produce materials with very fine grains is the application of severe plastic deformation on the prototype with coarse grains. In this method, the grain size is reduced to the nanometer scale in several stages through applying strong strains to the sample, which leads to the improvement of mechanical and physical properties in the material. One of the most important methods of applying severe plastic deformation is the constrained groove pressing (CGP) process. According to studies, little research has been done on the weight loss of structures used in the military, maritime, aviation, and medical industries. Therefore, the mechanical behavior of the sheets was experimentally studied by the CGP method. The results show that the structure of ۷۰۷۵-T۶ aluminum particles decreased in size from ۶۰ microns to ۲۷۰ nanometers by increasing the steps of this process. Also, the yield strength in the fourth pass increased by ۳۸% compared to the annealed sample, and the tensile strength improved by ۳۴%. In addition, the percentage of longitudinal increases in the fourth pass is reduced to its lowest value, ie ۴۰%.
کلیدواژه ها:
Constrained Groove Pressing Process ، ۷۰۷۵ aluminum alloy ، Ultrafine-grained Materials ، Mechanical Properties
نویسندگان
Shahin Heidari
Bone and Joint Diseases Research Center, Shiraz University of Medical Sciences, Shiraz, Iran
Ahmad Afsari
Department of Mechanical Engineering, Shiraz Branch, Islamic Azad University, P. O. Box: ۷۱۳۴۸-۱۴۳۳۶, Shiraz, Iran