Slab analysis for roll force and torque in ring rolling with Coulomb friction model
محل انتشار: یازدهمین کنفرانس ملی مهندسی ساخت و تولید ایران
سال انتشار: 1389
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,332
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICME11_204
تاریخ نمایه سازی: 3 مرداد 1389
چکیده مقاله:
In this paper, an analytical solution for the ring rolling process is presented based on the slab method. Non uniform distribution of stresses through the deforming zone has been taken into account in this formulation. The effects of the process key parameters on rolling pressure, force and torque were investigated. Considering the variations in these parameters, an equivalent friction factor for any friction coefficient was obtained and a simple relation for these two features in this process was proposed. Comparing the analytical results of this model with the experimental results of other investigators, good agreements were observed.
کلیدواژه ها:
Ring rolling - Friction coefficient - Friction factor - Slab method
نویسندگان
A. Parvizi
Ph.D. Student, School of Mechanical Engineering, College of Engineering, University of Tehran
K. Abrinia۲,
Associate Professor, School of Mechanical Engineering, College of Engineering
M. Hamedi۳
Associate Professor, School of Mechanical Engineering, College of Engineering
S.M Moosavi
Ms.C. Student, School of Mechanical Engineering, College of Engineering, University of Tehran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :