Presenting Three Design Methods for Axial Compressor Blade via Optimization
سال انتشار: 1397
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 486
فایل این مقاله در 14 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JCARME-8-1_010
تاریخ نمایه سازی: 19 خرداد 1398
چکیده مقاله:
Improving the efficiency of compressors has been one of the most important goals of researchers over the years. In this paper, three different methods are presented for parameterization and blade optimization of axial flow compressor. All methods consist of flow analysis tool, optimization algorithms, and parametric geometry generation tool, that are different in each approach. Objective function is defined based on the aerodynamic performance of blade in the acceptable incidence angles range. A DCA blade is used as the initial guess for all methods. The performance of optimized blades and the initial blade are compared for evaluating the capability of various methods that a good agreement has been achieved. The results show that the value of performance improvement in each method depends on the number and type of the chosen parameters. All three methods have improved blade performance at the design incidence angle. However, only the first method shows significant performance improvement in off-design conditions.
کلیدواژه ها:
نویسندگان
Omid Fathi
Department of Mechanical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran.
Hadi Kargarsharifabad
Energy and Sustainable Development Research Center, Semnan Branch, Islamic Azad University, Semnan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :