Enhancement abrasion resistance of ductile cast iron by applying two-step austempering process

سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,561

فایل این مقاله در 21 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ICME07_081

تاریخ نمایه سازی: 6 آذر 1388

چکیده مقاله:

Due to the low wear resistance of the as-cast ductile iron (DI), it is thought to apply a developed austempering heat treatment process defined by two-step austempering process that enhance the mechanical properties as well as the wear property. In this study two DI alloys were used, the first one was unalloyed DI and the second contains 0.2% Cr. Two batches of samples were prepared for each alloy. The first batch was proceed by conventional (single-step) austempering treatment, where the samples were austenitized at 900 °C for 1 hour and then quenched in a salt bath at austempering temperature of 360 °C for 1 hour. A developed austempering process (or two-step austempering process) was applied on the second batch of samples. The samples were austenitized at 900 °C for 1 hour and then quenched consequently at 360 °C and while being kept at that temperature, the temperature of the salt bath was raised by 29 °C in 1 hour. So, the final austempering temperature reached 389 °C and then cooled directly by forced air. The correlation between microstructure, mechanical properties, as well as abrasion resistance has been done for both conventional (single-step) and two-step ADIs. The two-step (or developed) ADI achieved superior abrasion resistance than the conventional one. This marked improvement in abrasion resistance of the two-step ADI is attributed to the high amount of transformed fine ausferrite in the final structure. The wear mechanisms were also defined by means of studying the worn surface using scanning electronic microscope.

نویسندگان

Khaled M. Ibrahim

CMRDI, Cairo-Egypt

Ahmed Elsawy

TTU, Tennesse, USA

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • O. Celik, H. Ahlatci and E. Kayali; Wear, 256, (2005), ...
  • A.R. Ghaderi, M.N. Ahmadabal and H.M. Ghasemi; Wear, 255, (2003), ...
  • C. Lin and W. Lee; International Journal of Fatigue, Vol. ...
  • K.M. lbrahim; International Journal of Cast Metals Research, Vol. 18, ...
  • P.A. Reed, R.C. Thomson and K.K. Lee; Materials Science and ...
  • M.N. James and Li Wenfong; Materials Science and Engineering, A ...
  • H.P. Feng, S.C. Lee and C.H Hsu; Materials Chemistry and ...
  • S.K. Putatunda; mateials, and Design, 24, (2003), pp. 435-443. ...
  • R.C. Dommarco and J.D. Salvande; Wear, 254, (2003), pp. 230-236. ...
  • J. Ortiz, A.P. Cisilino and J.L. Otegui; Engineering Analysis with ...
  • _ Magalhaes and J. Seabra; Wear, 258, (2005), pp. 1755-1763. ...
  • J. Zimba, M. Samandi and T. Chandra; Materials and Design, ...
  • J.L. Garin and R.L. Mannheim; Journal of Materials Processing Technology, ...
  • M.A. Yescas, H.K. Bhadeshia and D.J. MacKay; Materials Science and ...
  • M.A. Yescas and H.K. Bhadeshia; Materials Science and Engineering, A333, ...
  • S.K. Putatunda; Materials Science and Engineering, A 315, (2001), pp. ...
  • J. Yong and S.K. Putatunda; Materials Science and Engineering, A ...
  • Yong and S.K. Putatunda; Materials and Design, Vol. 25, (2004), ...
  • J. Yong and S.K. Putatunda; Materials Science and Engineering, A ...
  • G.E. Dieter; Mechanical Metallurgy, Third ed., McGraw Hill, New York, ...
  • A.A. Torrance; Wear, 258, (2005), pp. 281-293. ...
  • K.M. lbrahim, H.N. Eldin, A.A. Nofal and M.M. lbrahim; Journal ...
  • S. Bogdanski and M. Trajer; Wear, 258, (2005), pp. 1265-1272. ...
  • W.A. Glaeser; Materials for Tribology, Tribology Series 20, Elsevier Science ...
  • Table 2: Analysis of retained austenite using X-ray diffraction Vol. ...
  • نمایش کامل مراجع