Simulation of Excavator Bucket Pressuring Through Finite Element Method
محل انتشار: ژورنال مهندسی عمران، دوره: 4، شماره: 3
سال انتشار: 1397
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 358
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_CEJ-4-3_002
تاریخ نمایه سازی: 6 آذر 1397
چکیده مقاله:
Excavator bucket tool is one of the most important parts of an excavator. It is made of steel mixture. It is commonlyequipped with protruding teeth on its cutting side to breakdown hard materials and also to prevent dryness and damage ofthe bucket. Excavator bucket tooth must have supporting geometrical shape to penetrate and to endure the digging processon the ground, gravels, stones, or any other abrasive field. It is because of the field’s natural characteristic when the buckettool grinds the material. Mixed iron is common to be used as excavator bucket tool’s material because it is easy to get andeconomic. High hardness value is also needed on the surface that transports hard material such as mining equipment.Therefore, an accurate analysis should be done to determine the suitable material on this field. Design and analysis weredone by using Computer-Aided Engineering (CAE) Abaqus 6.10 application to get the maximum tension as the result ofloading. Analysis process to get the tension was done by adding 8285.06 N weight forces in static condition with the angleof 32o to the horizon. From the analysis it could be known that maximum tension experienced by excavator bucket toothis 209.3 MPa, and it is still below the Maximum Equivalent von Mises stress so the design could be categorized as safe.
کلیدواژه ها:
نویسندگان
Sumar Hadi Suryo
Department of Mechanical Engineering, University of Diponegoro, Semarang, Indonesia
Athanasius Pirharyoto Bayusno
Department of Mechanical Engineering, University of Diponegoro, Semarang, Indonesia
Jamari
Department of Mechanical Engineering, University of Diponegoro, Semarang, Indonesia
Gilang Ramadhan
Department of Mechanical Engineering, University of Diponegoro, Semarang, Indonesia