Drive and readout circuits for Micro-Electro-Mechanical gyroscopes in CMOS technology

سال انتشار: 1396
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 372

فایل این مقاله در 12 صفحه با فرمت PDF و WORD قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

TESCONF01_084

تاریخ نمایه سازی: 16 تیر 1397

چکیده مقاله:

In this study, the design and simulation of a drive and readout circuit for a microelectromechanical sensor (MEMS) is developed. The design of the readout circuit of the capacitance variations of gyroscope sensor is the most important part of the design that includes a continuous-time converter capacitance to the voltage using a T-shaped trans-impedance amplifier to detect capacitance variations and an output signal amplifier to reach the optimum level. These circuits are simulated using Hspice and Cadence 16.6 software in 0.18µm CMOS technology. In this study with ±1.8V supply voltage, the followings have been achieved: gain and cutoff frequency of the designed operational amplifier is 108dB and 6.25MHz, gain and cutoff frequency of TIA is 130dB and 30MHz, power consumption of the TIA is 6.5mW, output-referred noise is 0.558nV/√Hz and finally the power consumption of the whole circuit is 200mW. The improvements of the result compared to the previously reported values is significant.

کلیدواژه ها:

نویسندگان

Sayed mohammad ali zanjani

Department of Electrical Engineering, Najafabad branch, Islamic Azad University, Najafabad, IRAN.

Ehsan etemadnia

Department of Electrical Engineering, Najafabad branch, Islamic Azad University, Najafabad, IRAN.