Modeling, Simulation and Comparing Control Methods of Doubly-Fed Induction Generator in Wind Energy Conversion Systems
محل انتشار: کنفرانس بین المللی مهندسی برق
سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 723
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICELE01_120
تاریخ نمایه سازی: 21 شهریور 1395
چکیده مقاله:
One of the most widely used methods for the utilization of wind energy is the use of doubly fed induction generator. The doubly-fed generators are better in the applications of limited-range speed control and large capacity case due to the partially rated inverter, high reliability and lower cost. This study presents three different approaches to control doubly fed induction generator. Three cases of the best and most privileged control methods, vector, direct torque and direct power control are implemented.This paper presented the most common methods to control doubly fed induction generator in wind turbine. It is a quality and quantities compares between the three methods to determine which one will be implemented in terms of performance and simple structure. Results shows that DPC method cause of simple structure and operating in high speed is better than others. In this paper simulation is based on stator flux by accurate parameters of generator in matlab/Simulink
کلیدواژه ها:
نویسندگان
omid rahmani
University of Shahid Rajae Teacher Training, Iran
zahra mokhtari
University of Shahid Rajae Teacher Training, Iran
mohmaad cheshfar
University of Shahid Rajae Teacher Training, Iran
zhale amirjamshidi
University of Shahid Rajae Teacher Training, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :