Fabrication and Characterization of Inorganic-Conducting Polymer-Based BHJ Polymer Solar Cells

سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 572

فایل این مقاله در 5 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

CHCONF02_234

تاریخ نمایه سازی: 9 مرداد 1395

چکیده مقاله:

In this work TiO2 and Ag-TiO2 nanoparticles were synthesized via sol-gel process and applied as electron acceptors in the fabrication of polymer solar cells. Researches show that compositing of conducting polymers as an important component of polymer solar cells with inorganic nanoparticles can improve the charge dissociation in the active layer. It can also enhance the interfaces between the active layer and the metal electrode which in turn this leads to a higher charge collection at the electrodes and higher power conversion efficiency. The synthesized nanoparticles were characterized by x-ray diffraction spectroscopy and scanning electron microscopy equipped with energy dispersive x-ray (EDX) unit. Results confirmed the successful synthesis of anatase TiO2 and Ag-TiO2 nanoparticles with a homogenous size distribution of approximately 20 nm. The variations in the band gap of the polymer as a function of the type of applied nanoparticles were monitored using cyclic voltammetry. In order to study the effect of the type of inorganic nanoparticles on the photovoltaic performance of the polymer solar cells the following devices where prepared: ITO/TiO2 paste/P3HT/Au, ITO/TiO2 paste/P3HT:TiO2/ Au and ITO/TiO2 paste/P3HT:Ag- TiO2/ Au. The J-V characterization of these devices showed that Ag-TiO2 possessed the most improving impact on Jsc, Voc and FF of the devices.

نویسندگان

Zahra Fakharan

Ph.D. candidate, Department of Chemistry, Amirkabir University of Technology

Leila Naji

Assistant Professor, Department of Chemistry, Amirkabir University of Technology