Springback Measurement in Reverse Cup Drawing Process
سال انتشار: 1387
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,157
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISME16_933
تاریخ نمایه سازی: 20 آبان 1386
چکیده مقاله:
This paper discusses a finite element analysis of springback and the effects of different process parameters in the reverse cup drawing process, taken from the NUMISHEET'99 benchmark. The simulations are preformed for an aluminum alloy. The results are ompared with those reported in the literature. The forming process is simulated in ABAQUS/Explicit while the springback simulation is performed in ABAQUS/Standard. The utilized method is probing a relationship between the springback and other important factors such as initial blank thickness die gap and also
hardening models. It will be shown that increasing the initial blank thickness and decreasing the die gap leads to springback reduction in the cup. Considering the required maximum punch load for different values of initial blank thickness and die gap reveals that these parameters should be controlled appropriately. Moreover, comparing the results for different hardening models shows that the combined hardening considers the softening of the material in the stage of the process than the isotropic hardening.
کلیدواژه ها:
نویسندگان
Iman Zafarparandeh
MSc. Student Department of Mechanical Engineering, Ferdowsi University of Mashhad
Mehran Kadkhodayan
Associate Professor Department of Mechanical Engineering, Ferdowsi University of Mashhad
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :