Samand Structural improvement to fulfill the European Safety Regulations

سال انتشار: 1384
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,826

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:


تاریخ نمایه سازی: 23 آذر 1384

چکیده مقاله:

Full frontal crash (ECE33), Rear Crash (ECE34), Bumper impact (ECE42) and door intrusion (FMVSS 214) are the main safety targets in the design of Samand which have been reached satisfactorily. However, Samand structure is not strong enough to fulfill the two remained - Offset crash (ECE 94) and Side impact (ECE 95) – European safety regulations. To eliminate this weakness following study has been conducted.These two regulations’ criterions are based on the level of injuries for driver and passenger. But prior to assessing the dummy injuries, the vehicle structure should have stable and reliable performance in the crash event. Therefore, based on our previous experiences, some structural guide lines have been set (on the deformation and velocity of structural locations) for the first phase. Achieving these targets, dummy injuries has been studied in order to clarify whether the restraint system should be modified to fulfill the regulation criterions or not.To find the final solution, offset frontal and side impact finite element models have been updated and several iterative analyses were performed. Geometry modeling has been done by means of CATIA software while PATRAN and Pam-Crash have been utilized for finite element modeling and processing, respectively. The results show that the recommended structural solution is enough for achieving the side impact targets but for fulfilling the offset frontal crash criterions besides of recommended structural solutions the restrain systems should be modified and driver airbag should be implemented in vehicle.

کلیدواژه ها:


Alireza Kamalan

MSc. in Mechanical engineering, CAE specialist, IKCo R&D Center

Sharif Shahbeyk

MSc. in Structural engineering, CAE specialist, IKCo R&D Center.

Farhad Hajianfar

MSc. in Mechanical engineering, CAE specialist, IKCo R&D Center.