Online Monitoring of Flow Front Arrival by Ultrasonic Waves in an Injection Molding Process
سال انتشار: 1393
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 817
فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISME22_730
تاریخ نمایه سازی: 14 مرداد 1393
چکیده مقاله:
Nondestructive ultrasonic test using Pulse-echo technique has been performed to online monitoring in plastic injection molding process of a cubic part. The received signal amplitudes versus the injection time have been saved as a diagram for each point on the outer interface between the melt plastic and the mold wall. Using the acquired diagrams, detachment process and the time of emerging air gaps which are formatted due to polymer shrinkage, have been online monitored. This information are required to investigate solidifying phase and also the cooling phase which have being gathered superior with using the conventional pressure sensors. Flow front arrival has been online monitored and the time of arrival of the melt polymer at each point has been determined. Thus the last point where the melt plastic reaches i.e. the position of the air venting openings has been obtained.
کلیدواژه ها:
نویسندگان
H Ahangar-Darabi
Faculty of Mechanical Engineering, Department of Mechanical Engineering, Islamic Azad university, Sari branch, Iran