Improving the Lubricity of GTL Diesel through Controlled Partial Oxidation over a Fe/Mn/KMnO۴/SiO۲ Catalyst
محل انتشار: نشریه پیشرفته شیمی، دوره: 10، شماره: 2
سال انتشار: 1406
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 67
فایل این مقاله در 23 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_AJCS-10-2_003
تاریخ نمایه سازی: 22 آبان 1405
چکیده مقاله:
Fischer-Tropsch-derived gas-to-liquids (GTL) diesel has a high cetane number and very low sulfur and aromatic contents; however, its highly paraffinic composition and lack of naturally occurring polar compounds result in poor lubricity. This study evaluated an additive-free approach based on controlled partial oxidation over a Fe/Mn/KMnO۴/SiO۲ catalyst. Oxidation was carried out in a ۱,۵۰۰ mL glass reactor at atmospheric pressure using ۱ L of GTL diesel and ۱۰ g of catalyst. The reaction was conducted at ۱۱۰-۱۳۰ °C for ۶ h under an oxygen flow of ۳-۵ L·h⁻¹ and stirring at ۱,۲۰۰ rpm. The initial fuel had a High-Frequency Reciprocating Rig (HFRR) wear scar diameter (WSD) of ۶۸۰ µm. After ۶ h of oxidation, the WSD decreased to ۳۳۲.۸ µm, which was below the applied limit of ۴۶۰ µm. Density increased from ۷۷۵.۸ to ۷۸۷.۳ kg·m-۳, while kinematic viscosity at ۴۰ °C increased from ۲.۵۶ to ۳.۰۱ mm۲·s-۱. Only minor changes were observed in the cold filter plugging point and cloud point. Fourier-transform infrared spectroscopy (FTIR) and gas chromatography-mass spectrometry (GC-MS) indicated the formation of oxygenated compounds containing -OH, C-O, and C=O functionalities. ASTM D۲۸۸۷ simulated distillation showed that the boiling-range profile remained within the diesel fraction. ASTM D۲۲۷۴ total insolubles increased from ۰.۳۱ to ۲۱.۶۳ g·m-۳ but remained below the applied limit of ۲۵ g·m-۳. The cetane number decreased from ۷۴.۰ to ۷۲.۴ but remained above the minimum requirement of ۷۰. The oxidation experiment was conducted as a single reactor run, and the triplicate fuel-property measurements represented analytical replicates rather than independent process replicates. These results demonstrate that controlled partial oxidation can substantially improve the lubricity of GTL diesel while maintaining its principal fuel properties within the applied specification limits. However, the increase in total insolubles indicates that prolonged oxidation narrows the oxidation-stability margin and should be considered during further process optimization.
کلیدواژه ها:
نویسندگان
- -
Central Plant Laboratory, Uzbekistan GTL LLC, Nishan, Uzbekistan
- -
Department of Analytical Chemistry, Termez State University, Termez, Uzbekistan
- -
Department of Organic Chemistry, Termez State University, Termez, Uzbekistan
- -
Department of Organic Chemistry, Termez State University, Termez, Uzbekistan
- -
Department of Organic Chemistry, Termez State University, Termez, Uzbekistan
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :