synergistic Effects of Bed Macroroughness and Positive Inclination on the Morpho dynamics and Energy Dissipation of Hydraulic JumpsAmin
محل انتشار: ماهنامه عمران و پروژه، دوره: 8، شماره: 8
سال انتشار: 1405
نوع سند: مقاله ژورنالی
زبان: فارسی
مشاهده: 28
فایل این مقاله در 31 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_CIPR-8-8_003
تاریخ نمایه سازی: 22 آبان 1405
چکیده مقاله:
Hydraulic jumps are a critical phenomenon in fluid mechanics, widely utilized in hydraulic engineering structures such as energy dissipation basins. These structures — including relaxation ponds located downstream of spillways, steep channels, and control valves — rely on the energy-dissipating characteristics of hydraulic jumps to manage and reduce the destructive force of fast-moving water before it continues downstream. To better understand the behavior and effectiveness of hydraulic jumps under various conditions, a series of controlled laboratory experiments were carried out. A total of ۶۰ experimental runs were performed using a rectangular flume measuring ۳۵ centimeters in width. The inlet Froude numbers tested ranged from ۴ to ۱۲, covering a broad spectrum of supercritical flow conditions. Throughout the study, two distinct types of bed roughness were examined — sharp corner roughness and diamond (rhombus) shaped roughness elements — both installed on the channel floor. In addition to roughness type, the longitudinal slope of the flume bed was systematically varied between ۰% and ۰.۳% to assess its influence on jump characteristics. During each experimental run, several key hydraulic parameters were precisely recorded, including discharge rate, sequent depth ratio, jump length, water surface profile, flow depth upstream and downstream of the jump, and water head measurements at the weir crest. The findings of the study revealed meaningful differences in hydraulic jump behavior depending on the roughness configuration. Specifically, the presence of sharp corner roughness elements led to a notable reduction in the ratio of jump length to sequent depth — approximately ۳۵.۵% lower compared to a smooth bed. Furthermore, the sequent depth ratio increased by an average of ۶.۵% for sharp corner roughness. In contrast, diamond-shaped roughness showed a more modest influence, producing only a ۱.۲% average reduction in the jump length-to-sequent depth ratio
کلیدواژه ها:
نویسندگان
امین ارال
Department of Civil Engineering, Sep. C., Islamic Azad University, Sep, Iran
روزبه اقامجیدی
MSC of Civil engineering , Sep. C., Islamic Azad University, Sep, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :