A Novel Approach to Utilizing Engine Waste Energy to Enhance Thermal Efficiency and Cooling in Diesel Engines

سال انتشار: 1405
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 31

فایل این مقاله در 26 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_IJCCE-45-11_011

تاریخ نمایه سازی: 21 آبان 1405

چکیده مقاله:

This research presents a comprehensive numerical investigation of a longitudinally finned double-pipe heat exchanger designed for waste heat recovery from the exhaust gases of a Perkins ۱۱۰۴ diesel engine. A three-dimensional conjugate heat transfer analysis was performed using ANSYS Fluent Computational Fluid Dynamics (CFD) software, employing the RNG k-ε turbulence model under actual engine operating conditions. The study systematically evaluates the thermal-hydraulic performance of the exchanger with varying fin heights (۸, ۱۶, and ۲۴ mm). The results demonstrate that increasing the fin height from ۸ mm to ۲۴ mm reduces the exhaust gas outlet temperature by approximately ۲۶.۲ °C and elevates the water outlet temperature by about ۱۶.۴ °C. This corresponds to a ۴۳ % increase in the Nusselt number. However, the hydrodynamic performance shows a ۲۵۵% increase in gas-side pressure drop for the ۲۴ mm fin compared to the ۸ mm fin, accompanied by a significant rise in the friction factor (from ۰.۵ to ۱.۵). Although the ۲۴ mm fin provides the highest heat transfer, its pressure drop penalty is ۷.۹ times higher than the plain tube, making it economically unjustified despite its superior thermal performance. A comprehensive performance evaluation using the Performance Evaluation Criterion (PEC) identified the ۱۶ mm fin height as the optimal configuration, providing an effective compromise between enhanced heat transfer and acceptable pressure loss. The proposed heat recovery system shows strong potential for recovering energy from engine exhaust. It contributes to improved engine thermal efficiency, reduced specific fuel consumption, and mitigation of greenhouse gas emissions. The findings confirm the effectiveness of CFD as a robust tool for the design and optimization of waste heat recovery systems in constrained industrial applications.

کلیدواژه ها:

Waste Heat Recovery (WHR) ، Diesel engine ، Double‑Pipe Heat Exchanger (DPHX) ، Longitudinal Fins ، Computational Fluid Dynamics (CFD) ، Performance Evaluation Criterion (PEC)

نویسندگان

- -

Mechanical Engineering Department, Faculty of Engineering, University of Sistan and Baluchestan, Zahedan, I.R. IRAN

- -

Department of Engineering, Meybod University, Meybod, I.R. IRAN

- -

Mechanical Engineering Department, Faculty of Engineering, University of Gonabad, Gonabad, I.R. IRAN

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Perkins Engines Company Limited, Industrial Diesel Engines – ۱۱۰۰ Series, (۲۰۲۴) ...
  • Chintala V., Kumar S., Pandey J.K., A Technical Review on ...
  • Hatami M., Ganji D.D., Gorji-Bandpy M., Optimization of Finned-Tube Heat ...
  • Hoang A.T., Waste Heat Recovery from Diesel Engines Based on Organic ...
  • Jouhara H., Khordehgah N., Almahmoud S., Delpech B., Chauhan A., ...
  • Gupta S.K., Verma H., Yadav N., A Review on Recent ...
  • Huminic G., Huminic A., Application of Nanofluids in Heat Exchangers: ...
  • Ravi R., Pachamuthu S., Design and Development of Innovative Protracted-Finned Counter ...
  • Ravi R., Pachamuthu S., Kasinathan P., Computational and Experimental Investigation on ...
  • Hatami M., Ganji D.D., Gorji-Bandpy M., Investigations of Fin Geometry ...
  • El Maakoul A., Metoui I., Abdellah A.B., Dimane F., Performance ...
  • Hussein H., Freegah B., “Study the Effect of Various Fin Configurations ...
  • Mousavi S.M., Azizi A.S., Tlili I., Optimized Design of Helical-Finned ...
  • Haw W., Oon C.S., Lau E.V., Analysis of Hydrodynamics and ...
  • Singh S.K., Khan V., Kacker R., Thermal Performance Optimization of ...
  • Gandjalikhan Nassab S.A., Ansari A.B., Jahanshahi Javaran E., Waste Heat ...
  • Peng H.S., Chen W.H., Chen C.L., Heat Transfer Analysis and ...
  • Alkalibi A., Alahmadi Y.H., Tlili I., Performance Analysis of an ...
  • Investigation of Effective Parameters on the Thermo-Hydrodynamic Characteristic of Nanofluid Flow at a Double-Pipe Heat Exchanger with Ultrasonic Assistance [مقاله ژورنالی]
  • Bahrami H.R., Sharifi A.E., Application of Multilayered Porous Media for ...
  • Dubey N., Kumar A., CFD Analysis and RSM-Based Optimization of Performance ...
  • Alshehery S., Alsaikhan K., Harharah H.N., Harharah R.H., Alamry A., ...
  • Montazerifar F., Akbari O.A., Javadpour S.M., Multi-Optimization of Nanofluid and ...
  • Al-Haboobi A., Al-Muslimawi A.H., A New Algorithm for Solving Thermal ...
  • Abed A.M., Alshukur M., Al-Khafaji S., Tlili I., Heat Transfer ...
  • Han Y., Wang X., Cheng Z., Ma Y., Parameter Analysis ...
  • Mostafa M., Ashabi A., Hryshchenko A., Bruton K., O'Sullivan D.T.J., A ...
  • Ravi R., Pachamuthu S., Experimental Investigation on Innovative Waste Heat Recovery ...
  • Ali S., Ahmed Z., Khan M., Raza A., Abbas S., Diesel ...
  • Raman M., Selvam C., Kumar P., Balasubramanian V., Studies on ...
  • Hong T.D., Pham M.Q., Truong P.T., Study on Heat Exchanger Structural ...
  • Furqan M., Alwatban A., Heat Transfer in Double Pipe Heat Exchangers ...
  • Javadpour S.M., Farahat S., Ajam H., Salari M., Hossein Nezhad ...
  • Gholizadeh A., Pourfallah M., Gholinia M., Armin M., Languri E., ...
  • نمایش کامل مراجع