Effect of Cadmium on Structure, Corrosion, and Magnetic Properties of Polymer–Spinel Ferrite Composite Coatings Deposited by EPD
سال انتشار: 1405
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 38
فایل این مقاله در 15 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_CHAL-14-2_001
تاریخ نمایه سازی: 20 آبان 1405
چکیده مقاله:
High-entropy spinel ferrites (HESFs) have emerged as promising multifunctional materials due to their tunable magnetic and corrosion properties. In this study, composite coatings composed of six high-entropy spinel ferrite compositions and polyethyleneimine (PEI) were deposited on copper substrates via electrophoretic deposition (EPD). The effects of Cd incorporation and polymerization time (۱۵ and ۳۰ h at ۱۸۰ °C) on microstructure, magnetic behavior, and corrosion performance were systematically investigated. Zeta potential values shifted from near-neutral (+۱.۵۷ to −۰.۹۴ mV) to more negative values (−۶.۸۱ to −۱۰.۴۶ mV) after ۳ min under an electric field, indicating improved electrophoretic mobility. Uniform coatings were obtained under optimized conditions (۲۰۰ V, ۳ min, ۲ g/L SDS). Increasing polymerization time enhanced coating cohesion but promoted crack growth, especially in Cd-containing samples.All coatings exhibited ferromagnetic behavior, although magnetic parameters decreased compared to powders due to polymer-induced dilution and reduced interparticle interactions. Electrochemical results showed that Cd incorporation reduced corrosion current density from ۲.۱۵ μA/cm² to as low as ۰.۱–۰.۵ μA/cm², indicating improved corrosion resistance. However, increasing polymerization time could increase icorr (e.g., from ۰.۱ to ۵ μA/cm²) due to crack propagation. EIS analysis revealed a maximum total resistance of ~۷۵۴۴ Ω·cm², confirming enhanced corrosion protection under optimal conditions. Overall, coating performance is governed by the interplay between composition, polymerization, and microstructure, and optimal conditions are essential for achieving high-performance multifunctional coatings.
کلیدواژه ها:
نویسندگان
Morteza Khosravi
Department of Materials Engineering, Faculty of Engineering, University of Sistan and Baluchestan, Zahedan, Iran.
Shahriar Sharafi
Department of Materials Engineering and Metallurgy, Faculty of Engineering, Shahid Bahonar University of Kerman, Kerman, Iran
Ahmad Irannejad
Department of Materials Engineering and Metallurgy, Faculty of Engineering, Shahid Bahonar University of Kerman, Kerman, Iran