Effect of Increments Quantity on Determination of Residual Stresses inIncremental Hole Drilling Technique
محل انتشار: کنفرانس دو سالانه بین المللی مکانیک جامدات تجربی
سال انتشار: 1392
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,004
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
WMECH02_037
تاریخ نمایه سازی: 21 تیر 1393
چکیده مقاله:
Experimental determination of residual stresses in thin sheets has been implemented by hole drilling method. The incremental hole drilling technique is suggested as an acceptable technique for determination of residual stress variation in thickness. In the present research, basic formulations of converting experimentally measured strains into residual stress profiles have been studied. The number of increments in drilling process affects the results. Two different set of tests have been used for investigating this effect. A unidirectional tension test and a four point bending test are simulated by FEM and the four point bending test (with same condition) is done experimentally. The drilling test has been applied in 10, 20 and 40 increments. Comparison of the experimental and numerical results with analytical result shows that by increasing the increment numbers, higher precision can be obtained and stress profile results will be improved.
کلیدواژه ها:
نویسندگان
M Sedighi
Associate Professor
M. M Shokrieh
Professor
M Tahmasbi
MSc Student
J Joudaki
PhD Student, Department of Mechanical Engineering, Iran University of Science & Technology, Narmak, ۱۶۸۴۶۱۳۱۱۴, Tehran, Iran,
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :