Removal of Maxilon Red Dye by Adsorption and Photocatalysis: Optimum Conditions, Equilibrium, and Kinetic Studies

The present work has for the main objective the elimination of the textile dye Maxilon Red (MR) by coupling two processes, adsorption on activated clay followed by photocatalysis over the wurtzite ZnO. The influence of the physical parameters like the initial pH, adsorbent dose of the activated clay, MR concentration, and temperature have been studied. The best adsorption yield occurs at neutral pH ~ ۷ within ۶۰ min with an adsorption percentage of ۹۷% for MR concentration of ۲۵ mg/L and an adsorbent dose of ۰.۵ g/L. The data were suitably fitted by the Langmuir model with a maximum adsorption capacity of ۱۷۵ mg/g. To investigate the adsorption mechanism, the adsorption constants were determined from the pseudo-first-order, pseudo-second-order, and intraparticle diffusion models. It was found that the MR adsorption is well described by the pseudo-second-order kinetic. The thermodynamic parameters ΔH˚ = -۱۷.۱۳۸ kJ/mol, ΔS˚ = ۳۲.۸۴ J/mol.K, and ΔG˚=−۶.۴۱۹ to−۷.۳۲۹ kJ/mol with rising temperature from ۲۵ to ۵۰˚C indicated that the adsorption is exothermic and spontaneous. The second part of this work was devoted to the photocatalytic degradation onto ZnO under solar irradiation of the residual MR concentration, which remained after adsorption. In this respect, the effect of ZnO dose and MR concentration has also been investigated. The photodegradation rate reached ۹۹% under irradiation within ۹۰ minutes under the optimum conditions. The parametric study showed that the elimination is very effective by photocatalysis, based essentially on the in situ generations of free radicals •OH which are non-selective and very reactive. The present study shows that the activated clay is an effective low-cost adsorbent for the removal of Maxilon red from an aqueous solution.

کلیدواژه ها:

Maxilon Red ، activated clay ، Adsorption ، Photodegradation ، ZnO