Chemical Modification of Proton Exchanger Sulfonated Polystyrene with Sulfonated Graphene Oxide for Application as a New Polymer Electrolyte Membrane in Direct Methanol Fuel Cell

A novel composite membrane is prepared by the dispersion of Sulfonated Graphene Oxide (SGO) in sulfonated polystyrene–polyethylene (SPS-PE) for electrolyte in the direct methanol fuel cell. For sulfonated polystyrene used the method that was patented by Makowski et al. Graphene Oxide (GO) is prepared by modified Hummer's method and is further functionalized with SO۳-H. SGO is then incorporated into SPS-PE matrix using the solvent cast method to form the composite membrane. The composite membranes are characterized by FT-IR, TGA, and SEM. Oxidative resistance, water uptake, ionic conductivity, and methanol permeability are measured to evaluate its performance in a direct methanol fuel cell with a cation exchanger membrane. The membranes were confirmed to retain ۱–۵% water vapor at ۸۰–۱۴۰ °C in the air due to the hydrophilic of highly SPS and SGO. The ionic conductivity and permeability of the membrane to methanol were found to increase with temperature increasing. The membrane SGO-SPS–PE shows the proton conductivity of ۲.۷۴ × ۱۰-۲ S/cm at ۱۰۰ °C without extra humidity supply and is very promising for high temperatures with low humidity. The high proton conductivity is ascribed to the unique composition in which the heterocyclic polymer provides the proton motion by construction diffusion and the highly SGO-SPS copolymer retains water vapor to lower the activation energy for proton conduction.

کلیدواژه ها:

Condensate Stabilization ، Simulation ، ASPEN HYSYS ، feasibility study ، Stripping