Investigating the Effect of Temperature, Molar Ratio of Ethylene Glycol to Oil, and Catalyst Amount on BioLube Production Yield of Neem Seed Oil
سال انتشار: 1401
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 206
فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJCCE-41-10_029
تاریخ نمایه سازی: 17 خرداد 1404
چکیده مقاله:
Excessive use of petroleum-based lubricants and their hazardous disposal has increased environmental pollution; hence the need for eco-friendly lubricants has been increased to meet the requirements of industry and automotive. Due to the oil crisis, the world’s attention has been diverted to producing bio-lubricants from non-edible sources. The use of non-edible sources can overcome the problems of toxicity, hazardous nature, and non-biodegradability. This study discusses the effect of various parameters on transesterification reaction to produce bio lubricant from Neem oil. The dried neem seeds were crushed, and the oil was extracted using the Soxhlet extraction method using n-hexane. The bio lube was produced by a double transesterification process using CaO as a catalyst. The effect of temperature, the molar ratio of ethylene glycol to oil, and catalyst wt% on yield bio lubricant was observed. The temperature varied from ۱۱۰ to ۱۴۰ °C, molar ratios of ethylene glycol to oil varied from ۲:۱ to ۸:۱, and the catalyst wt% was ۰.۸ to ۱.۶%, keeping the reaction time and other conditions constant. During the experimentation, it was observed that the yield was low at ۱۱۰°C, but as the temperature increased, yield also increased, but no significant change in yield was observed beyond ۱۳۰°C. The maximum yield observed at ۱۳۰°C, and ۱۴۰°C was ۹۳.۷% and ۹۴.۳۷%, respectively. Similarly, as the molar ratio increases, the yield of bio lube also increases, and the maximum conversion was ۹۴.۳% achieved at ethylene glycol to oil molar ratio of ۸:۱, but a molar ratio ۶:۱ may be considered optimum because there is no substantial increase in conversion after ۸:۱. Moreover, the profile was observed by varying the amount of catalyst and it is evident from the results, as the amount of catalyst increases as the conversion increases from ۶۶% to ۹۵%; however, at a catalyst ratio of ۱.۶ wt %, a yield was decreased slightly to ۹۴.۲. It has been observed that the temperature significantly impacts the production yield of Biolube.
کلیدواژه ها:
نویسندگان
Nadia Khan
Polymer and Petrochemical Engineering Department, NED University of Engineering and Technology, Karachi, PAKISTAN
Syed Taqvi
Chemical Engineering Department, NED University of Engineering and Technology, Karachi, PAKISTAN
Rafiq Ahmed
Polymer and Petrochemical Engineering Department, NED University of Engineering and Technology, Karachi, PAKISTAN
Bilal Kazmi
Department of Applied Chemistry and Chemical Technology, University of Karachi, Karachi, PAKISTAN
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :