A Two-degree-of-freedom Tool-holder Mechanism for Real-time Adjustment of Tool Angles in Turning Process
محل انتشار: ماهنامه بین المللی مهندسی، دوره: 37، شماره: 11
سال انتشار: 1403
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 13
فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJE-37-11_003
تاریخ نمایه سازی: 23 تیر 1403
چکیده مقاله:
Tool geometry has a significant impact on cutting mechanics and key machining parameters such as tool life, workpiece surface quality, specific cutting energy, and dynamic stability of the cutting process. In the turning process, where the cutting tool remains in a fixed position, it is possible to develop a mechanism to adjust the tool angles during machining. This research introduces a new tool-holder mechanism for the lathe that can adjust the side inclination and front inclination angles. The simultaneous control of these angles allows for precise adjustment of the normal rake and clearance angles of the tool. Since these angles greatly affect all machining parameters, this mechanism can enhance the quality of the machining process. By implementing an active chatter control system using the proposed mechanism, the controller can reduce the tool’s clearance angle to increase process damping and prevent chatter. The mechanism enables adjustment of the normal rake and clearance angles by up to ۸ degrees. Test results demonstrate that utilizing this mechanism and the provided chatter suppression/control technique can effectively prevent chatter at higher machining speeds and improve machining stability. The proposed mechanism has potential applications in advanced CNC lathes with open architecture for precise and optimal adjustment of machining parameters.
کلیدواژه ها:
نویسندگان
H. Behroz
Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
H. Baseri
Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
H. Nourmohammadi
Northern Research Center for Science & Technology, Malek Ashtar University of Technology, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :