Examining effect of shape and location of opening on the behavior of corrugated steel plate shear walls

سال انتشار: 1402
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 130

فایل این مقاله در 12 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

CAUCONG03_044

تاریخ نمایه سازی: 16 اردیبهشت 1403

چکیده مقاله:

In the past three decades, the uses of steel plate shear walls due to advantages such as stiffness, ductility, strength and high energy absorption, to resist the lateral forces is considered. Due to the low buckling load of these walls, the stiffener used to improve their behavior, but using stiffener with practical problems such as increasing the time of construction is caused by the installation of the stiffener. So, the use of corrugated plate as shear wall due to high buckling load and no having difficulty using stiffener, in recent decade have been welcomed by researchers. Since the opening existence due to equipment and architectural reasons is inevitable in some cases, and opening can be placed in different locations of shear wall or having different forms, this paper examines the effect of shape and location of opening on the behavior of corrugated steel plate shear walls; For this purpose, opening is located in nine place from plate shear wall, as well as the investigated opening forms include square, rectangle, circle, ellipse and triangle. The ABAQUS software is used in the analysis of the models, and the structural behavior as non-linear (including materials and geometry non-linear behavior) is considered.

کلیدواژه ها:

Shear wall ، shape and location of opening ، corrugated plate ، buckling

نویسندگان

Shahrokh Moghufeh

Master of structural engineering, Razi university, Kermanshah, Iran

Hamid Reza Ashrafi

Assistant professor, faculty engineering, Razi university, Kermanshah, Iran