Investigating the effect of gas flow rate and amount of zinc oxide nanoparticles on the efficacy of photocatalytic oxidation process of nitrogen oxide from waste airstream
محل انتشار: مجله علمی مروری، دوره: 4، شماره: 7
سال انتشار: 1394
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 103
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_SJR-4-7_001
تاریخ نمایه سازی: 7 اسفند 1402
چکیده مقاله:
Nitrogen oxides are one of the most important air pollutants in environment and industrythat due to the adverse health and environmental effects should be refined before discharging into the environment. The photocatalytic oxidation method of nitrogen oxide into nitrogen Dioxide for better absorption insolutions is a promising method for removing of nitrogen oxides. Laboratory system used in this study is included of a source of gas source, mixing chamber, photocatalytic oxidation reactor, measuring system for nitrogen oxidation. Zinc oxide nanoparticles which were simulated by UV-A radiation would be used for photocatalytic oxidation. Inlet concentration of nitrogen oxide and the amount of stabilized nanoparticles in reactor for converting nitrogen oxide into nitrogen dioxide has been investigated. Results showed that the amount of monotonic converting of nitrogen oxide into nitrogen dioxide in the amount of Nano-particles is stabilized ۸mg/cm۲ for inlet concentration ۱۰۰,۱۵۰,۲۰۰ ppm and respectively equivalent to ۱۵, ۲۶ and ۳۲%. This study showed that increasing concentration of inletnitrogen oxide in system, reduce the capacity of photocatalytic oxidation for converting nitrogen oxide into nitrogen dioxide.Nitrogen oxides are one of the most important air pollutants in environment and industrythat due to the adverse health and environmental effects should be refined before discharging into the environment. The photocatalytic oxidation method of nitrogen oxide into nitrogen Dioxide for better absorption insolutions is a promising method for removing of nitrogen oxides. Laboratory system used in this study is included of a source of gas source, mixing chamber, photocatalytic oxidation reactor, measuring system for nitrogen oxidation. Zinc oxide nanoparticles which were simulated by UV-A radiation would be used for photocatalytic oxidation. Inlet concentration of nitrogen oxide and the amount of stabilized nanoparticles in reactor for converting nitrogen oxide into nitrogen dioxide has been investigated. Results showed that the amount of monotonic converting of nitrogen oxide into nitrogen dioxide in the amount of Nano-particles is stabilized ۸mg/cm۲ for inlet concentration ۱۰۰,۱۵۰,۲۰۰ ppm and respectively equivalent to ۱۵, ۲۶ and ۳۲%. This study showed that increasing concentration of inletnitrogen oxide in system, reduce the capacity of photocatalytic oxidation for converting nitrogen oxide into nitrogen dioxide.
کلیدواژه ها:
نویسندگان
Haji Omid Kalte
Department of Occupational Health Engineering, Faculty of Medical Sciences, TarbiatModares University, Tehran, Iran
Ahmad Jafari Jonidi
Iran University of Medical science, Faculty of Health, Teharn, Iran
Hasan Asilian
Department of Occupational Health Engineering, Faculty of Medical Sciences, TarbiatModares University, Tehran, Iran
Ardalan Soleymanian
Department of Occupational Health Engineering, Faculty of Medical Sciences, TarbiatModares University, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :